Lanier AP206 - Manual (Page 82)

Replacing Consumables
69
4
Note
❒ Before removing the photoconduc-
tor unit from the printer, spread
paper or some other material
around the area you are working
to keep the toner from making the
floor dirty.
❒ The “Change PCU” message is
based on a printed page counter
kept internally by the printer. It is
meant as a general guide to photo-
conductor unit life only. Actual
photoconductor unit life depends
on the printing conditions.
A
Make sure that the Data In indica-
tor is not lit or flashing, and then
press the printer's power switch
to turn off the power.
B
Open the front cover by pulling
the front cover open lever and
open the top cover by pulling the
top cover open lever.
Important
❒ Be sure to open both the top and
front covers before removing
the photoconductor unit. Fail-
ure to do so can result in dam-
a g e t o t h e s u r f a c e o f t h e
photoconductor unit.
Note
❒ If the printer is equipped with
the paper feed unit (optional)
and the duplex unit (optional),
first open the upper portion of
the duplex unit, and then open
the top cover of the printer.
C
Stand up the green lock levers to
a vertical position.
D
Hold the inset grip of the photo-
conductor unit, pull it straight up,
and remove it from the printer.
E
Remove the new photoconductor
unit from the box. ZDGH110J
ZDGH120J
ZDGH130J