Lanier AP206 - Manual (Page 127)

Appendix
114
6
Low Memory
The error message shown below is output by the printer whenever there is not
enough memory to print your data.
The following are the actions you should take when you encounter memory
shortage problems. If these actions do not solve the problem individually, try
them in combination with each other.
A Increase printer memory.
Install the optional memory unit to increase the amount of printer memory .
Reference
For more information about how to install the optional memory unit, see
the "Setup Guide" that comes with the printer.
For more information about kinds of optional memory units, see P.118
“Options”.
B Reduce the resolution.
With the IPDL-C printer driver: On the [Print Quality] tab, select [Custom] and
click [Setting/Change]. Then set the resolution to 300dpi.
With the RICOH-SCRIPT2 printer driver: Set the resolution to 300dpi.
C Turn on “Image Memory”.
Use the printer's “System Menu” to turn on “Image Memory”.
⇒ P.90 “System
Menu”
There is not enough memory in your printer to print this page.
Change print quality in the printer driver and try again.
For details, please refer to the troubleshooting section in your manual.