Lanier AP206 - Manual (Page 45)

Paper and Other Media
32
3
B
Slide the paper guides to posi-
tions that match the size of paper
you want to load.
C
Load paper into the tray with the
side to be printed facing up.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
(
T) inside the tray.
❒ The front and side guides should
be set to the correct paper size to
avoid paper feed problems.
❒ Load only plain paper in the pa-
per feed unit. To print on thick
paper, adhesive labels, OHP
transparencies or envelopes,
use the standard tray.
❒ To avoid paper multi-feeds,
shuffle sheets before loading
them in the tray.
D
Slide the paper tray into the paper
feed unit until it stops.
Important
❒ Be sure to insert the paper tray
completely, or paper misfeeds
might occur.
❒ If the paper size shown on the
panel display differs from the
size of paper actually loaded,
re-adjust the position of the pa-
per guides.
ZDGY060J
ZDGY070J
ZDGY080J