Menu> j ipdl-c menu l, List print> j 1.config.page l, Menu> j list print l – Lanier AP206 User Manual
Page 77: Menu> j maintenance l, Maintenance> j 1.toner level l
Troubleshooting
64
4
Adjusting the Setting of
Registration of the Paper Tray
Adjusting the registration refers to
changing the position of the printed
image on paper fed from the optional
tray so it matches that of the standard
tray. Probably you will never need to
perform this procedure.
Note
❒ Use A4 or 8
1
/
2
”
×11” paper to print
the configuration page.
A
Turn on the printer's power switch.
B
Press
{{{{Menu}}}}.
The following message appears on
the panel display.
<Menu> j
IPDL-C Menu l
C
Press
{{{{T
T
T
T}}}} or {{{{U
U
U
U}}}} to display "List
Print", and then press
{{{{#Enter}}}}.
The following message appears on
the panel display.
<List Print> j
1.Config.Page l
D
After confirming that "1.Config.Page"
is displayed, press
{{{{#Enter}}}}.
E
Press
{{{{#Enter}}}} again.
This prints the configuration page.
Important
❒ If printing does not start, check
the panel display for any error
messages and take the action re-
quired to correct the problem.
⇒ P.36 “Error & Status Messages
on the Operation Panel”
F
After confirming that "1.Con-
fig.Page" is displayed, press
{{{{Es-
cape
}}}}.
The following the message ap-
pears on the panel display.
<Menu> j
List Print l
G
You can find the crop marks on
the long edge of the configuration
page. Check if the left and right
margins on the long edge of the
configuration page are as shown
in the illustration.
H
If the left and right margins are
not the same, press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to
display "Maintenance", and then
press
{{{{#Enter}}}}.
<Menu> j
Maintenance l
The following message appears on
the panel display.
<Maintenance> j
1.Toner Level l
Power
On Line
Data In
Reset
Escape
Menu
Media
Enter
Error
ZDHS031E