Lanier AP206 - Manual (Page 56)

Error & Status Messages
43
4
Rear Cover Open The rear cover is open. Close the rear cover. ⇒ the
"Setup Guide" that comes
with the printer
Time to Change Fuser Cleaner It is time to replace the fuser
cleaner.
Replace the fuser cleaner. ⇒
P.76 “Replacing the Fuser Clean-
er”
Time to Change Fusing Unit It is time to replace the fusing
unit. Contact your sales or service
representative.
Time to Change PCU It is time to replace the photo-
conductor unit. If printed side gets dirty, re-
place the photoconductor
unit.
⇒ P.68 “Replacing the
Photoconductor Unit”
Time to Change XX It is time to replace the unit in-
dicated by XX. Contact your sales or service
representative. XX indicates
the unit to be replaced as fol-
lows: T1: Transfer drum R1:
Pick-up roller for the standard
tray R2: Pick-up roller for the
paper feed unit D1: Paper dis-
charger
Toner is Empty A toner cartridge runs out. Replace the toner cartridge. ⇒
P.66 “Replacing the Toner Car-
tridge”
Top Cover Open The top cover remains open. Close the top cover.
TransferRoller:NotSetCor-
rectly The transfer roller is not in-
stalled correctly. Contact your sales or service
representative.
Tray2 : Not Set Correctly The paper feed unit (option) is
not installed correctly. Install the paper feed unit cor-
rectly.
⇒the "Setup Guide"
that comes with the printer
Warming Up The printer is preparing for
printing. Wait until the printer is
warmed up.
Waste Toner is Full The waste toner bottle is full. Replace the waste toner bottle.
⇒ P.75 “Replacing the Waste
Toner Bottle”
XXX: Not Set Correctly The indicated toner cartridge
is not installed correctly. Install the indicated toner car-
tridge correctly.
⇒ P.66 “Re-
placing the Toner Cartridge”
xxx Toner is Empty The indicated toner is low or
has run out. Replace the indicated toner
cartridge.
⇒ P.66 “Replacing the Toner
Cartridge”
Message Description Comments