Lanier AP206 - Manual (Page 38)

Paper and Other Media Supported by This Printer
25
3
❖ ❖ ❖ ❖ Thick paper
• If you print on paper heavier than 105 g/m 2 (28 lb) (up to 160 g/m
2
(43 lb)),
use the standard tray or the Paper Cassette Type204 (option). The print
quality on paper that is thicker cannot be guaranteed.
• Make sure that the stack of paper is not higher than the LABEL upper limit
mark (
T) inside the tray.
Note
❒ The number of sheets that can be loaded may vary depending on the pa-
per thickness and paper type.
• When printing on thick paper, you should select the thick paper mode
with the printer driver.
• Auto duplex printing onto thick paper is not available.
❖ ❖ ❖ ❖ Adhesive labels
• When printing on adhesive labels, use the standard tray or the Paper Cas-
sette Type204 (option).
• Load adhesive labels into the tray with the print side face up.
• Remove any unused adhesive labels from the tray after you are finished
printing. Leaving them in the tray can cause them to curl.
• When printing on adhesive labels, you should select the plain paper mode
with the printer driver.
• The standard tray or the Paper Cassette Type204 can hold up to 30 sheets
of adhesive labels.
Note
❒ The number of sheets that can be loaded may vary depending on the pa-
per thickness and paper type.
• In auto duplex printing, do not use adhesive labels.
• Make sure that the stack of paper is no higher than the LABEL upper limit
mark (
T) inside the tray.
❖ ❖ ❖ ❖ OHP transparencies
• When printing on OHP transparencies, use the standard tray or the Paper
Cassette Type204 (option).
• Load OHP transparencies into the tray with the print side face up or they
may stick to the fusing unit and cause a misfeed.
• Remove any unused OHP transparencies from the tray after you are fin-
ished printing. Leaving them in the tray may cause them to stick together.
• When printing on OHP transparencies, you should select the OHP trans-
parency mode with the printer driver.