Lanier AP206 - Manual (Page 83)

Troubleshooting
70
4
F
Remove the left and right pins
from the new photoconductor
unit.
G
Remove the protective sheet from
the new photoconductor unit.
Note
❒ The white powder on the photo-
conductor unit is to protect it af-
ter installation into the printer.
This white powder does not
have any adverse effect on the
interior of the printer.
H
Insert the new photoconductor
unit so that the green axles on
both sides are aligned with the
tracks inside the green lock le-
vers. Lower it until the gears
mesh securely.
Important
❒ When inserting the photocon-
ductor unit, be careful not to
damage the surface of it.
I
Return the green lock levers to
their original positions.
Important
❒ Do not return lock levers with
force. If you cannot lock them
easily, pull the photoconductor
unit from the printer. Then in-
sert it again until the gears mesh
securely. After that, try return-
ing the levers to their original
positions.
ZDGH610J
ZDGH611J
ZDGH140J
ZDGH150J