Lanier AP206 - Manual (Page 104)

Menu Settings
91
5
❖ ❖ ❖ ❖ 4. Energy Saver
You can select after how many minutes the printer should enter the Energy
Saver mode if no operation is performed. The Energy Saver mode reduces
electric power consumption.
• 5min
• 15min
• 30min
• 45min
• 60min
Important
❒ After the printer enters Energy Saver mode, it takes some time to warm up
again when print data is received.
❖ ❖ ❖ ❖ 5. Transfer
You can select the data transfer speed of the parallel interface. If you are hav-
ing trouble with data transfers, try changing this setting to “Normal”.
• Hi-speed
• Normal
❖ ❖ ❖ ❖ 6. Image Memory
This setting controls what the printer does when the printer memory is insuf-
ficient to print a certain page.
• On
• Off
Note
❒ “Off” causes the message shown below to be printed when there is insuf-
ficient memory to process.
❒ Selecting “On”reduces the resolution of the image to reduce memory re-
quirements.
❖ ❖ ❖ ❖ 7. Parallel
You can select the parallel interface timing setting. Normally it is not neces-
sary to change this setting.
• ACK Inside
• ACK Outside
• STB Down
There is not enough memory in your printer to print this page.
Change print quality in the printer driver and try again.
For details, please refer to the troubleshooting section in your manual.