LSI 53C810A User Manual
Page 171
Transfer Control Instructions
6-31
If the comparisons are false, the LSI53C810A fetches the
next instruction from the address pointed to by the
register and the instruction
pointer is not modified.
Interrupt Instruction
The LSI53C810A can do a true/false comparison of the
ALU carry bit, or compare the phase and/or data as
defined by the Phase Compare, Data Compare, and
True/False bit fields.
If the comparisons are true, then the LSI53C810A
generates an interrupt by asserting the IRQ/ signal.
The 32-bit address field stored in the
register can contain a unique
interrupt service vector. When servicing the interrupt, this
unique status code allows the ISR to quickly identify the
point at which the interrupt occurred.
The LSI53C810A halts and the
register must be written before starting any further
operation.
Interrupt on-the-Fly Instruction
The LSI53C810A can do a true/false comparison of the
ALU carry bit or compare the phase and/or data as
defined by the Phase Compare, Data Compare, and
True/False bit fields. If the comparisons are true, and the
Interrupt-on-the-Fly bit is set (bit 2), the LSI53C810A
asserts the Interrupt-on-the-Fly bit.
SCSIP[2:0]
SCSI Phase
[26:24]
This 3-bit field corresponds to the three SCSI bus phase
signals which are compared with the phase lines latched
when SREQ/ is asserted. Comparisons can be performed
to determine the SCSI phase actually being driven on the
SCSI bus. The following table describes the possible
combinations and their corresponding SCSI phase.
These bits are only valid when the LSI53C810A is
operating in Initiator mode. Clear these bits when the
LSI53C810A is operating in Target mode.