Lenovo 6532 - Manual (Page 179)

– device.cat
• For Linux based operating systems:
– cdc_interface.sh
4. After you install ASU, Type the following commands to set the DMI:
asu set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> [access_method]asu
set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> [access_method]asu set
SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> [access_method]
Where:
<m/t_model> The server machine type and model number. Type
mtm xxxxyy, where xxxx is the machine type and
yyy is the server model number.
<s/n> The serial number on the server. Type sn zzzzzzz,
where zzzzzzz is the serial number.
<asset_method> The server asset tag number. Type asset
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa, where
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the asset
tag number.
[access_method] The access method that you select to use from
the following methods:
• Online authenticated LAN access, type the command: [host <imm_internal_ip>] [user
<imm_user_id>][password <imm_password>]
Where:
imm_internal_ip The IMM internal LAN/USB IP address. The
default value is 169.254.95.118.
imm_user_id The IMM account (1 of 12 accounts). The default
value is USERID.
imm_password The IMM account password (1 of 12 accounts).
The default value is PASSW0RD (with a zero 0
not an O).
Note: If you do not specify any of these parameters, ASU will use the default values. When the default
values are used and ASU is unable to access the IMM using the online authenticated LAN access
method, ASU will automatically use the following unauthenticated KCS access method.
The following commands are examples of using the userid and password default values and not
using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model>
user <imm_user_id> password <imm_password>asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n> user <imm_user_id>
password <imm_password>asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag>
user <imm_user_id> password <imm_password>
Examples that do use the userid and password default values:
asu set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>asu set SYSTEM_PROD_DATA.SysInfoSerialNum
<s/n>asu set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted): You do not need to specify a value for
access_method when you use this access method.
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI driver
be installed. Some operating systems have the IPMI driver installed by default. ASU provides the
Chapter 6 . Replacing FRUs 171