Lenovo 6532 - Manual (Page 181)

5. Update the server configuration (see “Updating the server configuration” on page 174).
6. Slide the server back into the rack, if necessary.
7. Turn on the peripheral devices and the server.
Connecting the cables
The following illustration shows the locations of the input and output connectors on the front of the server.
1 Power-on LED 6 System-error LED
2 Power-control button 7 USB 1 connector
3 Reset button 8 USB 2 connector
4 Hard disk drive activity LED 9 Hard disk drive activity LED (green)
5 Locator LED 10 Hard disk drive status LED (amber)
The following illustration shows the connectors and LEDs on the rear of the server.
1 Power-cord connector 9 NMI button
2 Serial connector 10 USB 3-4 connector
3 Ethernet 1 activity LED 11 USB 1-2 connector
4 Ethernet 1 link LED 12 Video connector
5 Ethernet 2 activity LED 13 Power supply error LED (amber)
6 Ethernet 2 link LED 14 DC power LED (green)
7 PCI slot 1 15 AC power LED (green)
8 PCI slot 2
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling instructions. It might be
easier for you to route cables before you connect the devices to the server.
Cable identifiers are printed on the cables that come with the server and optional devices. Use these
identifiers to connect the cables to the correct connectors.
Chapter 6 . Replacing FRUs 173