Lenovo 6532 - Manual (Page 43)

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 7 “Parts listing, RS210 Types 6531, 6532, 6533, and 6534” on page 175 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by “(Trained service technician only),” that step must be performed only by
a trained service technician.
Array %1 is in critical condition.(%1 =
CIM_ComputerSystem.ElementName) Error An array is in Critical
state.(Sensor = Drive n
Status)(n = hard disk drive
number) Replace the hard disk drive that is
indicated by a lit status LED.
Array %1 has failed.(%1 =
CIM_ComputerSystem.ElementName) Error An array is in Failed
state.(Sensor = Drive n
Status)(n = hard disk drive
number) Replace the hard disk drive that is
indicated by a lit status LED.
Memory uncorrectable error detected
for DIMM All DIMMs on Memory
Subsystem All DIMMs. Error A memory uncorrectable
error has occurred. 1. If the server failed the POST
memory test, reseat the
DIMMs.
2. Replace any DIMM that is
indicated by a lit error LED.
Note: You do not have to
replace DIMMs by pairs.
3. Run the Setup utility to enable
all the DIMMs.
4. Run the DSA memory test.
Memory Logging Limit Reached
for DIMM All DIMMs on Memory
Subsystem All DIMMs. Error The memory logging limit
has been reached. 1. Update the server firmware to
the latest level.
Important: Some cluster
solutions require specific code
levels or coordinated code
updates. If the device is part
of a cluster solution, verify
that the latest level of code
is supported for the cluster
solution before you update the
code.
2. Reseat the DIMMs and run the
DSA memory test.
3. Replace any DIMM that is
indicated by a lit error LED.
Memory DIMM Configuration Error
for All DIMMs on Memory Subsystem
All DIMMs. Error A DIMM configuration error
has occurred. Make sure that DIMMs are
installed in the correct sequence
and have the same size, type,
speed, and technology.
Chapter 4 . Diagnostics 35