NEC UNIVERGE NEAX 2000 IPS - Manual (Page 190)

Chapter 9 Feature Descriptions
Page 9- 44 UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
Issue 6
Q-SIG Feature List
Calling/Connected Line ID Presentation (CLIP/COLP)/
Calling/Connected Name ID Presentation (CNIP/CONP)
CCIS Tandem Call-Calling Party Number (CPN) Delivery to
ISDN & Q-SIG Networks
Q-SIG Circuit Switched Basic Call - ETSI Version
Q-SIG Feature Descriptions
Calling/Connected Line ID Presentation (CLIP/COLP)/
Calling/Connected Name ID Presentation (CNIP/CONP)
In between Q-SIG networks, this feature allows calling or called party information, to be
displayed on the Dterm LCD. CLIP/COLP conforms to ETS 300 173 and IS-11572 network.
CNIP/CONP conforms to ETS 300 238 and IS-11572 network.
• Calling Line Identification Presentation (CLIP): Calling party number (ID) is displayed on
the called party's Dterm LCD.
• Connected Line ID Presentation (COLP): Called party number (ID) is displayed on the
calling party's Dterm LCD.
• Calling Name Identification Presentation (CNIP): Calling party information (Name ID) is
displayed on the called party's Dterm LCD.
• Connected Name Identification Presentation (CONP): Called party information (Name ID)
is displayed on the calling party's Dterm LCD.
This feature is also available when networking with a CCIS interface.
CCIS Tandem Call-Calling Party Number
(CPN) Delivery to ISDN & Q-SIG Networks
This feature is provided for the call from tie line (CCIS line or
Q-SIG) or a station, is sent to the public ISDN network (AT&T, NT, NI-2) or Q-SIG network.
Q-SIG Circuit Switched Basic Call - ETSI Version
This feature enables NEC’s PBX to connect to NEC’s PBX or other manufacturer by using
Layer 3 protocol for the signaling for the support of circuit mode bearer services at the Q
reference point.
Q-SIG conforms to ETS 300 172.