NEC UNIVERGE NEAX 2000 IPS - Manual (Page 28)

Chapter 1 Introduction
Page 1-22 UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
Issue 6
IPS DM/IPS DML System Capacity Cont
Capacity Per MC
Number of PHYSICAL MODULAR CHASSIS
1 2
Built-in Router Max. 1 card per Site
DTMF Sender Max. 32 circuits per system
DTMF Receiver 16 32
SN716 Desk Console 8
Attendant Terminal (Dterm ATT Position) Max. 8 per system
SMDR Interface
Max. 2 Interface ports (RS232)
Max 1 interface port (IP) per system
PMS Interface
Max. 1 Interface port (RS232)
Max 1 interface port (IP) per system
ACD / MIS or OAI Interface Max. 1 Interface port per system
Remote PIM over IP (Number of PIM for Remote
Sites)
Note 3
Up to 30 (depending on network)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization Code / Forced Account Code / Remote
Access to System(DISA) Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record Note 3 1024
Note 1: Each Modular Chassis has 8 Virtual LT Ports that can only be used to expand the PAD
channels from 24 to 32 using the 8IPLA w/24IPLA.
Note 2: The total number of trunk line and DTI channel shall be 256 or less. (Each trunk line and DTI
channels are required to assign the “Trunk Number” by system data programming and
maximum number of system parameter for “Trunk Number” is 256.)
Note 3: IPS DML only supports a maximum of 128 IP stations; IPS DML does not support built-in
SMDR. The IPS DML is a Stand Alone Only solution; Remote PIM’s off the IPS DML are not
supported.