NEC UNIVERGE NEAX 2000 IPS - Manual (Page 60)

Chapter 3 System Highlights
Page 3- 12 UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide
Issue 6
PEG Count
The PEG counter is used for maintenance purposes to verify various data in the system. PEG counters
can be set by system programming to start and stop by month, day, hour and minute. A system reset
will clear all PEG count data. The following data can be measured by PEG count.
Trunk PEG Count
Number of outgoing trunk seizure by Trunk Route
Number of tandem connections established
Number of times a busy station was encountered
Number of all types of calls to Attendant Console
Number of connections giving Dial Tone
Number of station-to-station connections established
Number of failures caused by all senders being busy
Number of failures caused by all registers being busy
Number of failures caused by all ringing trunks being busy
Number of failures caused by all IP-PAD channels being
Number of forced release of communication between station and Trunk/Tandem connection
Number of call forwarding caused by the calling number is not informed from network
Number of rejection of the incoming call the calling is not informed from network
Number of incoming call seizure-Trunk Route
Number of times all trunks found to be busy trunk route
Number of incoming calls terminated to busy tone-Trunk Route
Number of unanswered incoming calls-Trunk Route
Number of register connection on trunk call-Trunk Route
Number of conference calls (Three/Four way Calling)
Number of failures cased by all conference trunks (For three way Calling) being busy
Number of transferred incoming calls to Attendant Console or predetermined station, by Call
Forwarding-Don’t Answer
UCD PEG Count
Number of answered calls on UCD station
Number of incoming calls to UCD Group
Number of call waiting calls for predetermined time in queuing mode on UCD Group
Number of abandoned calls to UCD Group
Number of incoming calls to all busy of UCD Group
Number of incoming calls to UCD Group that were answered
Number of times queuing
Wireless PEG Count
Number of Call Origination
Number of Call Termination
Number of Location Registration
Number of Handovers
Number of Out of Cell
IP Network PEG Count
Number of times that traffic exceeded the limit bandwidth
Number of times that traffic exceeded the warning bandwidth
Maximum bandwidth used
Bandwidth used now