Xantrex Technology XMP 2600 - Manual (Page 111)

Power module setup System messages
OCP & CHNL SHUTDOWN
a combination of the above.
T.O. & CHNL SHUTDOWN
a combination of the above.
ARMED: RCL = TRIGGER
the Power Module is armed and the
Power Supply is currently in Channel
Programming Mode. In that situation,
pressing the RCL key sends a trigger to
the Power Module.
EXCESS POWER WARNING
the Main Mainframe Power Envelope (for
details, see “mainframe power envelope”)
has been exceeded.
EXCESS POWER SHUTDOWN
the Main Mainframe Power Envelope has
been violated. The main converter was
Shutdown.
MODULE CAUSED SHUTDOWN
an Internal Power Module caused the
main converter to shutdown (by itself).
* EXTERNAL SHUTDOWN *
an external (user supplied) signal caused
the main converter to shutdown.
*** PRIMARY FAULT ***
a main converter fault was detected.
92 XMP 2600 User’s Guide rev. 1.0