Xantrex Technology XMP 2600 - Manual (Page 90)

Sequence programming Preparing the sequence program
Display
details
When you edit the sequence program, the cursor (appearing as a blinking black
rectangle) is located at the upper row of the display pointing out the selected field.
The fields that make up a step display are explained below.
Step number
This is the number of the step being edited. To move to another step you simply
change the shown step number.
Amount of delay
The amount of delay the step will introduce when the sequence program is running.
The format of the displayed delay amount is: H:MM:SS (H=hours , MM=minutes ,
SS=seconds).
The step’s operation is performed after the delay period is over.
Operation
The operation the step being edited is to perform after the delay period is over.
This field does not have a fixed format – its appearance is changed depending on the
selected operation.
How to clear
the whole
program
To clear the entire sequence program, press the ENTER key.
The upper row of the display will show a confirmation request: “PRESS ENTER
TO DELETE ALL STEPS”:
To confirm the clear operation: press the ENTER key.
To abort the clear operation: press the DEL key.
Create / Edit a
step
To create / edit the sequence program, edit its individual steps.
To edit a step to select it first, then modify the amount of delay it will introduce and
select the operation it will perform.
Selecting a field
To select the field to edit, move the cursor so it points to the desired field. Use the
following guidelines for moving the cursor:
Press the ENTER key to move the cursor to the next field (move right).
The cursor moves in a cyclic manner.
Use the RIGHT and LEFT selection keys to move the cursor:
o For selection fields the cursor moves from field to field.
o For fields with a numeric value the cursor moves one digit at a
time.
Select the step to edit
There are two methods for selecting the step to edit (changing the displayed step
number):
XMP 2600 User’s Guide rev. 1.0 71