Xantrex Technology XMP 2600 - Manual (Page 91)

Preparing the sequence program Sequence programming
Use the UP and DOWN selection keys to flip the step number. The flip
operation can be performed on any of the two displayed digits:
Effect of flip up (increment) Effect of flip down (decrement)
“12” ”22” “12” ”02”
“12” ”13”
“19” ”20”
“12” ”11”
“10” ”09”
Enter a step number using the numeric entry keys:
o Press a single digit and confirm by pressing ENTER.
OR
o Enter a two-digit number.
Clearing the selected step
To clear a step’s amount of delay to zero and select the default operation, proceed as
follows:
Move the cursor to the step’s number.
Press the DEL key.
The default operation of a step is :STEP, i.e. go-to to next step (this
step will just introduce a delay).
Set the amount of delay
Move the cursor to point to one of the digits of the amount of delay, and proceed to
use one of the following courses of action:
Clear the delay
To clear the delay (set it to zero) press the DEL key.
Enter a numeric value
Use the numeric entry keys to enter a value in units of seconds.
Use the following guidelines to help you with the numeric entry:
Enter the value in seconds. If the entered value does not fill-up the field
you will need to use the ENTER key to confirm the value. The
confirmed value will be displayed in the format H:MM:SS.
For example:................... Press the digit 3 three times and press enter to
confirm a value of 333 seconds. The display of
the confirmed value will be: 0:05:33.
Use the Decimal Dot key to change the units of the digits entered so far.
For example:................... Press 2.10.20 to enter the value 2:10:20. For an
entry with less than 5 digits, end the entry by
pressing the ENTER key.
72 XMP 2600 User’s Guide rev. 1.0