Xantrex Technology XMP 2600 - Manual (Page 26)

Installation Rear Panel Description
The GPIB address is set as illustrated below:
address sw 5 sw 4 sw 3 sw 2 sw 1 address sw 5 sw 4 sw 3 sw 2 sw 1
1 © 16 © ©
2 © 17 © ©
3 © © 18 © © ©
4 © 19 © ©
5 © © 20 © © ©
6 © © 21 © © ©
7 © © © 22 © © © ©
8 © 23 © ©
9 © © 24 © © ©
10 © © 25 © © ©
11 © © © 26 © © © ©
12 © © 27 © © ©
13 © © © 28 © © © ©
14 © © © 29 © © © ©
15 © © © © 30 © © © © ©
GPIB (IEEE-
488)
Connector
The GPIB connector is labeled "IEEE-488". It is a standard IEEE-488 connector,
comprising a standard IEEE-488 interface.
Use good quality GPIB cables to ensure uninterrupted communications with the
XMP 2600.
RS-232
Connector
The RS-232 connector is labeled "RS-232". It complies with the RS-232
communications standard. The RS-232 interface is configured in DTE mode. The
connection to the host computer can be made using a pin-to-pin cable.
The connector’s pin out is as follows:
Pin # Signal
1 DTR
2 TX
3 RX
4 Not Connected
5 GND
6 DTR
7 CTS
8 RTS
9 Not Connected
The RS232 communication link
always uses hardware handshake
(CTS and RTS signals). If you do
not want to use hardware
handshake, short pins 7 and 8.
XMP 2600 User’s Guide rev. 1.0 7