AASTRA 6739i User Guide EN - Manual (Page 113)

Options Key
41-001317-05 REV01 – 06.2013
107
Sprecode Softkey
You can set a key to automatically activate specific services offered by the server by setting a key to "sprecode". For exam-
ple, if the sprecode value of *82 is configured, then by pressing the key, *82 automatically activates a service provided by
the server. The value you enter for this field is dependent on the services provided by the server. Contact your System
Administrator for information about available services.
Configuring a Sprecode Softkey
Use the following procedure to configure a Flash key on the 6739i IP Phone.
IP Phone UI
1. Press on the phone to enter the Options List.
2. Press the <Softkeys> key. By default, all of the softkeys that display are configured as “None”.
3. Press a <None> key. A softkey configuration screen displays.
4. In the “Type” field, press the <None> key. A screen displays with softkey keys.
5. Press the <Sprecode> function key to apply to the softkey.
6. In the "Label" field, enter a label to apply to this softkey.
7. In the "Value" field, enter the appropriate value for accessing specific services from the server.
Note:
For values to enter in this field, contact your System Administrator.
8. Press <Save> to save the softkey. The softkey applies to your phone immediately and displays on your idle screen.
9. Press the to return to the previous menu or press the to return to the idle screen.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
1. Click on Operation->Expansion Module.
Softkeys
2. Select from “Key 1” through “Key 55”.
3. In the "Type" field, select Sprecode.
4. In the "Label" field, enter a label to apply to this softkey.
5. In the "Value" field, enter the appropriate value for accessing specific services from the server.
Note:
For values to enter in this field, contact your System Administrator.
6. In the state fields, check (enable) or uncheck (disable) the "Connected" state for this softkey.
Expansion Module Keys
7. Select an expansion module key.
8. In the "Type" field, select Sprecode.
9. In the "Label" field, enter a label to apply to this softkey.
10. In the "Value" field, enter the appropriate value for accessing specific services from the server.
Note:
For values to enter in this field, contact your System Administrator.
11. Click Save Settings.