AASTRA 6739i User Guide EN - Manual (Page 181)

Additional Features
41-001317-05 REV01 – 06.2013
175
Preferred Line and Preferred Line Timeout
The 6739i has a feature called “preferred line” and “preferred line timeout”. If you enable the preferred line parameter on
your phone, after a call ends (incoming or outgoing), the display switches back to the preferred line. Next time you go off-
hook to make another call, you pickup on the preferred line. You can enable the preferred line parameter using the Aastra
Web UI at the location, Basic Settings->Preferences->General. You can also set a preferred timeout parameter that spec-
ifies the number of seconds it takes for the phone to switch back to the preferred line.
The following table provides the behavior of the preferred line focus feature with other features on the phone.
Note:
You can configure “Preferred Line” and “Preferred Line Timeout” using the Aastra Web UI only.
Phone Feature Preferred Line Behavior
call return The phone switches back to the focused line immediately after the call ends.
speed dial The line is already specified when the speed dial is created. The phone switches back immediately after the call
ends.
conference For incoming calls, the phone switches back immediately after the call ends.
transfer For incoming or outgoing calls, the current behavior is that the same line used to transfer the call does not
change. For incoming calls, the phone switches back immediately after the call transfers.
blf The phone switches back immediately after the call ends.
park The phone switches back immediately after the call ends.
voicemail The phone switches back immediately after the call ends.
redial The phone switches back immediately after the call ends.
dialing For incomplete dialing on a non-preferred line, the focus does not change if some digits are entered.
If no digits are entered or digits were cleared, the focus changes to preferred line after the time out has passed
without activities.
caller id If the "Switch UI Focus To Ringing Line" parameter is disabled, the User is able to see the Caller ID when the phone
switches the focus to the ringing line.
factory default Factory default and recovery mode clears the "preferred line" and "preferred line timeout" parameters, and the
phone operates in a non-preferred line mode.
Notes:
1. If you specify a value of “0” for the preferred line parameter, it disables the preferred line focus feature.
2. If you specify a value of “0” for the preferred line timeout parameter, the phone returns the line to the preferred line
immediately.