AASTRA 6739i User Guide EN - Manual (Page 126)

Options Key
120
41-001317-05 REV01 – 06.2013
Using the Paging Key
The following procedure describes the use of the Paging key on the IP Phone. The procedure assumes you have already
configured the Paging key using the Aastra Web UI.
10. In the "Value" field, enter a multicast IP address(es) and a port number for the Paging key. When you press this
key, the phone initiates an outgoing multicast RTP session to the specified address(es) using the specified port.
(For example, 239.0.1.15:10000).
Notes:
1. When you select Paging for the “Type” field, the “Line” field is disabled.
2. If you enter more than one multicast address, separate the address by a comma. For example,
239.0.1.15, 245.343.2.4:10000
11. To receive RTP steams for Group Paging, you must also configure the "Paging Listen Addresses" parameter at the
path, Basic Settings->Preferences->Group Paging RTP Settings. For more information about setting this param-
eter, see “
Group RTP Paging (receives RTP streams) ” on page 180 .
12. Click Save Settings.
IP Phone UI
Notes:
1. Recipient of a Paging call can set a global “Do Not Disturb” (DND) to ignore any incoming pages.
2. For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the
“Allow Barge-In” parameter setting and the “Idling/On Call” state.
1. On the IP Phone, press the softkey or expansion module key you configured for Paging (labelled as “Group 1” in
the following illustration).
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays as follows.
L1 John Smith 401
12 : 45pm
Mon Jan 1
John Smith
401
Group 1
LAB
ACD