Printronix PrintNet Enterprise - Manual (Page 138)

138
Chapter 4 Set Wireless Properties
LEAP is to enable LEAP operation.
Kerberos is to enable Kerberos operation.
Sub-Channel: Determines the channel for the radio frequency card:
1 through 15 and Default.
Transmit Power: Determines the wattage of the transmission power: Max
(100 mW - Default), 50% (30 mW), 25% (15 mW), 10% (5 mW), and
1% (1 mW).
Transmission Rate: Currently unavailable. Determines the rate of data
transmission from the radio frequency card to the access point: 1 MHz, 2MHz,
5 MHz, 11 MHz, and Automatic.
Preamble Length: Determines the size of the packet header generated by
the access point: Long, Short, or Default (set by the access point).
Profile: Determines the 802.11g Wireless (Wi-Fi) mode in which to operate.
International Roaming: Check this check box to enable roaming outside the
home country.
When you are finished, click Send to transmit the values to the printer.
NOTE: If the NIC has a password assigned to the user root , then a Telnet
root password is required. See “Security Tab” on page 63.
If you are not going to modify settings on any other tabs, you must update the
printer for the settings to take effect. Click
Update to update the printer.
IMPORTANT Make sure the settings match those configured in the Access Point.