Printronix PrintNet Enterprise - Manual (Page 273)

Application Name and Version Information
273
Modifying an Existing File
After opening an existing file, the process of building and modifying the
application starts. To save your work as a new file or subsequent
modifications of an existing file, do the following:
• Save As New File
Select File -> Save As. The application name is already assigned and the
version number is 1.00A. Select a folder name, enter a file name, and
click Save. The file is then stored on disk.
• Subsequent Saves
Select File -> Save. The Version Confirmation dialog box opens with save
options. See Figure 242.
Figure 242. Confirming the File Version
NOTE: If you do not change the application name, the ‘Save as new
application’ option is disabled. In this case, you must select one of the
first four options. ‘Save with current version’ is the default selection.
If you change the application name, ‘Save as new application’ is
enabled, allowing you to reset the version number to 1.00A.
The version numbers displayed with the options are the version
numbers the GPIO Manager will store in the file.
NOTE: Version number increment rules.
When a file reaches release level Z and you select ‘Save with new
release level’, the release level increments to AA.
For example, 1.01Z becomes 1.01AA.
When the release level reaches ZZ and the you select ‘Save with new
release level’, the release level resets to A and the revision number
increments. For example, 1.01ZZ becomes 1.02A.
When the revision number reaches 99 and you select ‘Save with new
revision number’, the revision number resets to 00, the release level
resets to A, and the version number increments.
For example, 1.99C becomes 2.00A.