Printronix PrintNet Enterprise - Manual (Page 260)

260
Chapter 6 Mapping
Preloaded Table
If a GPIO board is installed in the printer but no user defined mapping table
has been loaded, the printer will revert to a preloaded table.
Simple printer menus allow for programming three of the 11 (seven outputs,
four inputs) pre-defined interface signals to a particular polarity or logic
function that meets all typical print and apply requirements. They can also be
compatible with all the features available on other manufacturers’ external I/O
interfaces. This allows easy migration of Printronix T5000e or T5000r printers
to new or existing systems. Field interface is accomplished through an
industry standard 50-pin D type connector.
Input Function Notes
1 Reprint Requires 16 Mbyte Printer Memory Option
2 Start Print Polarity programmable via printer menu
3 Feed
4 Pause
5..8 Not Used
Output Function Notes
1 Ribbon Low
2 Ribbon Out
3 Media Out
4 Error/Service Required
5 End Print 8 modes selectable via printer menu
6 Data Ready/On Line Selectable via printer menu
7 Not Used
8 Power On