Initial state – Printronix PrintNet Enterprise User Manual
Page 216
216
Chapter
6
Overview
NOTE:
GPIO does not always acknowledge the PAA trigger. If you use this
feature, make sure the event is always acknowledged.
Figure 187. Power-Up Configuration – IO Tab, Initial State
The Power-Up Settings – IO tab contains two tabs, Initial State and Input
Debounce.
Initial State
Divided into three sections, this panel is used to define the initial state of the
GPIO board.
•
Opto-coupler In
This section has 8 icons, each representing a single input Opto-coupler.
An active icon means that the Opto-coupler will be active when the printer
is powered on. If an event is assigned to the Opto-coupler and its power
up state does not match its initial state, the action mapped to the event
will be performed at power up.
NOTE:
This only applies to opto coupler events defined by the selected
power-up table. Click the icon to toggle the state.
•
Opto-coupler Out
This section has 8 icons, each representing a single output Opto-coupler.
An active icon means that the Opto-coupler will be active when the printer
is powered on. Click the icon to toggle the state.