Printronix PrintNet Enterprise - Manual (Page 69)

Defining Printer Properties
69
Speed: The baud rate at which data transfers. This setting must match the
speed of the printer serial debug port. See Table 4 to determine the serial
debug port baud rate menu location for your printer model
Word Size: The number of data bits per character. Must be set to 8 bits.
Parity: Adds an error checking bit if set to Odd or Even. Since the word size
must be set to 8 for correct operation, parity should normally be set to None.
Stop Bits: Inter-character gap. Can be set to 1 or 2. The normal setting is 1.
Modem Control
Figure 53. Printer Properties: Connections – Serial/Modem Sub-Tab
Modem Control
Phone Number: Enter the phone number you wish to call.
Dial Method: Choose Tone or Pulse.
Call Back: Enter your phone number, and check Enable if you want to use it
as a call back number.
Table 4. Serial Debug Port Baud Rate Menu Location
Printer Model Menu
SL4M/T4M INTERFACES Printer Mgmt Baud Rate
SL5000r/T5000r PRINTER MGMT or Factory Baud Rate
SL5000e/T5000e Factory Baud Rate
P7000 PRINTER MGMT BAUD RATE
P5000 Factory PRINTER MGMT BAUD RATE