Printronix PrintNet Enterprise - Manual (Page 232)

232
Chapter 6 Event To Action Mapping
Enable GPIO Events This action allows the Event
Parser to start executing all
actions again. None
Reply to Host This action sends user defined
data to the host. Reply, Interface
Wait This action waits a specified time
before the next action on the same
event is performed.
Use the data field to specify the
time to wait. Only available if one
of the numeric data fields is
defined. Time to Wait in
milliseconds
PAA Control: Reset
CST Time to wait in msThis action will
reset the active CST. None
Select Mapping Table This action allows the user to
select the active mapping table.
This action is only enabled if there
is more than one mapping table. Name of Table to
switch to.
9
Data Field Performs an action on a user-
defined data field. If no data fields
are defined, the user is asked to
define data fields first. Destination, Operator,
Source, Type
9
Send Report
3 This action allows the user to send
a report to a destination. If no
reports are defined, the user is
asked to define reports first. Source, Destination,
Seconds
9
Timers/RTC
3 Performs an action on a user-
defined timer. If no timers are
defined, the user is asked to define
timers first. Timer, Action
9
1
Thermal only.
2
Impact only.
3 If no instances of this object type are defined, the user is prompted to define the types now.
If the user selects Cancel, the action will revert to the previous selected action.
Table 10. Event Actions and Parameters
Action Name Description Parameters
Security Key
Required