Printronix PrintNet Enterprise - Manual (Page 77)

Opening Configuration Files
77
Opening Configuration Files
To open a configuration file, select File Open . The Configuration Editor
loads the settings from the file you choose.
IMPORTANT These settings do not affect the current configuration or the active
printer status until the configurations are downloaded to the printer.
NOTE: The Configuration Editor displays only one configuration file at a time.
Be sure to save any changes before opening another configuration file.
If you load a configuration file that was created with PNE version 3.03H or
earlier, you may need to link the affiliated CST file. In this case, select
File Open again, and check the Link CST File check box. See Figure 61.
Navigate to the affiliated .cst file and double-click it (or single-click it and click
the Select button). Save the configuration file, and the CST information will
save to the new configuration file. (You will not need to link the CST file in the
future.)
NOTE: If you hover the pointer over the Link CST File check box, a screen
tip appears that describes this functionality.
Figure 61. Linking a CST File