Xylem ProLab 2000 - Manual (Page 27)

ProLab 2000 Operation
27 ba75577e05 11/2013
4.2.4 Navigation example 2: Setting the date and time
The meter has a clock with a date function. The date and time are
indicated in the status line of the measured value display. This
indication can be switched off. When storing measured values and
calibrating, the current date and time are automatically stored as well.
The correct setting of the date, time and date format is important for the
following functions and displays:
 Current date and time
 Calibration date
 Identification of stored measured values.
Therefore, check the time at regular intervals.
Note
After a drop of the voltage of the buffer batteries (empty batteries), the
date and time are reset and have to be adjusted again.
Setting the date, time
and date format
The data format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
1 In the measured value display:
Open the system menu with <MENU/OK
_
>
(press for approx. 2 s).
The meter is in the setting mode.
2 Using <
▲><▼> and <MENU/OK>, select and confirm the
System / Clock function menu.
The setting menu for the date and time appears.
3 Using <
▲><▼> and <MENU/OK>, select and confirm the Time
menu.
The seconds are highlighted.
4 Change and confirm the setting with <
▲><▼> and <MENU/
OK>.
The minutes are highlighted.
Time : 14:53:40
Date : 26.04.06
Date format : dd.mm.yy
System