Xylem ProLab 2000 - Manual (Page 87)

ProLab 2000 Operation
87 ba75577e05 11/2013
Quitting the display To quit the display of stored measuring datasets, you have the
following options:
 Switch directly to the measured value display with <MODE>.
 Quit the display and move to the next higher menu level with <ESC>
or <MENU/OK>.
4.9.4 Erasing the data storage
How to erase the measured value storage is described on page 84.
4.9.5 Displaying and downloading calibration records
You can display and then output to the interface the calibration data.
Note
ID sensors have to be connected to the meter.
Displaying the
calibration record
of a selected sensor
The calibration record of the last calibration can be found under the
Calibration / Calibration record menu item in the respective measuring
menu. To open it, activate the relevant measuring window in the
measured value display and press <MENU/OK>.
Displaying the
calibration records
of all sensors
The calibration records of the last calibration of all sensors can be
found under the Data storage / Calibration data storage menu item in
the system menu. In the measured value display, open the system
menu with <MENU/OK
_
>.
With the <CAL
_
> key you can go directly to the Calibration data
storage menu.