I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 21)

20
3.3 Network Deployment
General Connection (without PoE)
1. Connect RJ45 Ethernet cable to a switch. Use a Category 5 Cross Cable when
your network camera is directly connected to PC.
2. Connect the power cable from the Network Camera to a power outlet.
3. If you have external devices such as sensors and alarms, make the connection
from the general I/O terminal block
Power over Ethernet (PoE)
The Network Camera is PoE-compliant, allowing transmission of power and
data via a single Ethernet cable. Follow the above illustration to connect the
Network Camera to a PoE-enabled switch via Ethernet cable.
IP PTZ Camera
IP PTZ Camera