I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 61)

60
IR LED
The user can open and close the IR LED manually and set up the IR LED work
mode under this OSD mean. (Under normal operation
mode, the user can press IRIS OPEN and IRIS CLOSE to
adjust the IR LED power):
1)
CONTROL MODE:
AUTO: IR LED will be opened or closed automatically
according to the light conditions.
TIMING: LED will be adjusted according to Open and
Close Time.
OPEN: IR LED forcedly open
CLOSE: IR LED forcedly close
CAMERA: IR LED status (Open/Close) will be
synchronized with Camera day and night switching
2)
SENSITIVIRY:
Here the user can manually set the sensitivity from 1-5.
The smaller the number is, the lower light of the
environment will be when the IR LED on.
3)
IR LED POWER: Here the use can choose the power
mode covering: NORMAL, MATCH and USER.
NORMAL: Near IR LED will be turned on when wide
angle. and Far IR LED will be turned on when small
angle.
MATCH: The Near and Far IR LED will be turned on
and off automatically to match the zoom in and out.
USER: The user can manually adjust the Near and Far IR
LED.
4)
AUTO CONTROL: When it is on, the IR LED will
turn its power consumption to the standby status
which will effectively extend the service life of IR
LEDs. And under this mode, when objects appear in
the screen, the IR LED will turn its power consumption
back to the normal status.
5)
STANDBY POWER: When the AUTO CONTROL is
on, the user can set up the standby power here.
6)
STANDBY DELAY: Set up how long if there is not
moving object, the IR LED will turn into standby