I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 51)

50
Motion alarm: Enable Motion detection function and you can setup the
trigger schedule and detection area. Click and drag the left button of
Mouse to setup the detection and you also can select the motion sensitivity.
You can specify the linkage method (Such as Trigger alarm output, move
the PTZ camera preset position and notify via email) when an event
occurs.
Alarm trigger: The alarm trigger almost same as Motion alarm, please
refer the description of Motion alarm section.
Alarm interval: The trigger of alarm output will be triggered base on the
interval period.
Recording: Click this button to setup the type of triggered recording, storage
media and schedule recording. You can setup the Pre recording & Post
recording period with the video and picture format on difference storage
device. Please refer the detail process as below:
Recording: Enable the” Schedule” recording and you can select
“Continue recording “, “ Start recording when network failed” and
“ Schedule recording “ mode. As for the “ Start recording when
network failed” that will save the video clips on the SD card, please add
the SD card when you enable this recording mode.
“Triggered recording”: Setup Pre/Post recording period and maximum
period is 10 seconds.
“Recording parameters” :
Streaming ID: Select the video streaming which we want to recording.
Save mode: There are two modes “Over write when full “and “Keep
days “.
Pre-recording: The time you set to start recording before the
scheduled time or the event. For example, if an alarm triggers