I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera User Manual
Page 31
30
again will stop recording. The default path is C:\WebData\record.
6.
Screen: Display video of IP camera on the screen.
7.
Screen: Choice the video streaming on the screen.
8.
View: Click this icon to display the video of IP camera.
9.
Play Mode: Click this icon to choice the display speed or video quality will
be priority first.
10.
Setup: Click this icon to setup the parameters of IP camera.
11.
Pan/Tilt/Zoom button: Move the Pan/Tilt/Zoom position of IP Speed dome
camera, this function just effect for the IP PTZ camera only and the detail
description as below.
12.
Exit: Click this icon to exit the I.E. browser viewing.
Control the IP PTZ camera (FDMO-2MIP-20XIR)
Function description:
Enable the Track, Patten,
Scan, Preset, Tour function
Move the Left/ Right/ Up/
Down of PTZ camera
position via these buttons
Add/Delete/Call the Enable
the Track, Patten, Scan,
Preset, Tour function
Increase /Decrease the Pan/
Tilt/ Zoom speed
Press “+” for Zoom in,
Focus near and IRIS close.
Press “-” for Zoom out,
Focus far and IRIS open
Use the left key of mouse
to click and drag a
rectangle area in the
lower right direction,
then the dome system
will move the position to
the center and allow the
rectangle area to zoom in.
Use the left key of mouse
to drag a rectangle area in
the upper left direction to
move the position to the
center and allow the
rectangle area to zoom
out.
Press to turn on IR LED;
press again to turn off
Increase /Decrease the
Pan/ Tilt/ Zoom speed