I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 69)

68
SOFT ADDRESS SET
The use can set up the SOFT ADDRESS, SOFT
PROTOCOL and SOFT BAUD RATE under this
menu here to activate the soft address function. And
then the defined dome address by dip switch will be
disabled.
1)
Move the cursor to INPUT (under DOME ID) and
press IRIS OPEN to enter the mode of setting
dome ID, Move the joystick to position the cursor
beside :0 1 2 3 4 5 6 7 8 9” and press IRIS OPEN
to enter. And move the joystick again to select
numbers of dome ID and press IRIS OPEN to
confirm. The number selected will be input on the
upper line.
2)
Move the cursor to INPUT (the bottom menu) and
press IRIS OPEN to enter the mode of setting soft
address, Move the joystick to position the cursor
beside :0 1 2 3 4 5 6 7 8 9” and press IRIS OPEN
to enter. And move the joystick again to select
numbers of dome soft address and press IRIS
OPEN to confirm. The number selected will be
input on the upper line.
3)
Enable or disable the soft address function. Press
IRIS CLOSE to exit last step. Move the cursor to
to “SOFTADDRESS:ON/OFF”. Press iris open to
enter. Move the joystick up or down to select ON
of OFF. Press IRIS OPEN to confirm.
4)
Press OK to save and confirm all the settings and
press CANCEL to exit all the settings.