I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 37)

36
IP Property: Click this button to modify the current Internet protocol with
IPv4 or IPv6, IP address, enable/disable DHCP and DNS IP address. The
settings must be properly configured before you operate the IP camera over
network. IPv4 and IPv6 are both supported. Configure the NIC settings,
including the IPv4(IPv6) Address, IPv4(IPv6) Subnet Mask and IPv4(IPv6)
Default Gateway. Click Save to change the setting.
1.
If the DHCP server is available, you can check to automatically obtain an
IP address and other network settings from that server.
2.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~
9676.
3.
The Multicast sends a stream to the multicast group address and allows
multiple clients to acquire the stream at the same time by requesting a
copy from the multicast group address.
4.
Before utilizing this function, you have to enable the Multicast function
of your router and configure the gateway of the network speed dome.
5.
If the DNS server settings are required for some applications (e.g.,
sending email), you should properly configure the Preferred DNS Server
and Alternate DNS server.
6.
The router must support the route advertisement function if you select
Route Advertisement as the IPv6 mode.
PPPoE: If you have no router but only a modem, you can use
Point-to-Point Protocol over Ethernet (PPPoE) function. Click this button
to enable the PPPoE function, Enter User Name, Password, and IP address
for PPPoE access, then Save to change the setting and exit the interface.