I-View FDMO-2MIP-20XIR IP SpeedDome Network Camera - Manual (Page 40)

39
save the settings.
You can also click the Save icon with computer time checkbox to synchronize
the time of the IP Camera with the time of your computer.
PC Time: Select this item and IP camera will synchronize the Date/ Time
with your computer’s (or NVR) time as its time. Click the Save icon for
save the setting.
NTP Server: You can follow the instructions in this section to configure the
time which can be displayed on the video. There is Time Zone, Time
Synchronization, Daylight Saving Time (DST) functions for setting the time.
Time Synchronization consists of auto mode by Network Time Protocol
(NTP) server and manual mode. Configuring Time Synchronization by
NTP Server
(1) Check the checkbox to enable the Use NTP function.
(2) Entry IP address of NTP server and port of NTP server, 123 by default.
If the IP Camera is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44). If the IP Camera is set in
a customized network, NTP software can be used to establish a NTP server
for time synchronization.
UPnP: Click this button to enable the UPnP (Universal Plug and Play)
function. UPnP™ is a networking architecture that provides compatibility
among networking equipment, software and other hardware devices. The
UPnP protocol allows devices to connect seamlessly and to simplify the
implementation of networks in the house and corporate environments. With
the function enabled, you don’t need to configure the port mapping for each
port, and the camera is connected to the Wide Area Network via the router.
1. Check “Enable UPnP™ icon from settings interface.