Teledyne LeCroy SAS Suite User Manual - Manual (Page 129)

SASSuite User Manual Version 6.25
LeCroy Corporation
119
Step 7 Close the Properties dialog box by clicking the X in the top right corner.
The Properties dialog box closes.
Step 8 Drag the second event button to the cell immediately below the cell
occupied by your first event button. Note that an additional cell appears
marked "Drag an event here to add a sequence."
Step 9 Right-click on the first event button. A pop-up menu appears.
Note: Be sure to click on the button itself and not the cell. If you click the cell,
you will get a different menu with fewer options.
Step 10 Select Specify Actions. Notice
how this menu differs slightly from
the menu shown earlier in this
chapter. You will see three
options for advancing or restarting
a sequence:
• Advance the Sequence - Draws an
arrow that connects the selected
event button to the event button
below it. This option creates a
sequence.
•
Restart the Sequence - (Not visible in the menu above.) This option restarts
the entire sequence. This option appears once you have linked two or more
buttons in a sequence. This option draws an arrow upward from the selected
event button to the beginning of the sequence.
•
Restart All - Restart all sequences and counts. This option creates an arrow
pointing a cell marked "Restart All."
Step 11 Select Advance the Sequence. An arrow will appear that connects
the first button to the second.
Step 12 Right-click the second button and select Specify Actions. A
sub-menu appears.