Teledyne LeCroy SAS Suite User Manual - Manual (Page 49)

SASSuite User Manual Version 6.25
LeCroy Corporation
39
Recording
Status
During recording, the current recording status is displayed in the next segment of the
status bar. (Refer to previous screenshot for examples.) When recording is begun, one
of the following messages flashes (depending on the selected Recording Options):
• Trigger?
• Triggered!
• Uploading
After recording stops, The following occurs:
• Flashing message changes to Uploading data–x% done (x% indicates
the percentage completion of the data uploading process).
• Traffic data is copied to disk using a file named data[sn].sas where [sn]
is the serial number of the analyzer chassis; or the name you assign as
the default filename. You can also create a file name of your choice by
specifying one in the Recording Options window.
To abort the upload process, press the Stop button.
You are asked if you want to keep or discard the partially uploaded data.
When the data is saved, the Recorded Data file appears in the main display window, and
the Recording Status window is cleared.
• If the recording resulted from a Trigger event, the first Frame following
the Trigger (or the Frame that caused the Trigger) is initially positioned
second from the top of the display.
• If the recording did not result from a Trigger event, the display begins
with the first Frame in the traffic file.
Recording
Activity
During recording, the fourth segment from the left of the Status Bar displays Recording
activity as a series of vertical bars.
The more vertical bars that are displayed, the greater the amount of activity being
recorded. If there are no vertical bars, there is no recorded activity.
During uploading, the percent of the completed upload is displayed.
Search
Status
The rightmost segment displays the current search direction: Fwd (forward) or Bwd
(backward).