Teledyne LeCroy SAS Suite User Manual - Manual (Page 71)

SASSuite User Manual Version 6.25
LeCroy Corporation
61
The new sequence has been added (Sequence 0) and a default starting state (State 0)
has been created. To create the logic of the sequence, in the section under State 0 click
on "<Click here to add an event>" and a list of possible events appears. In the event type
list, we select "SCSI Status" and in the drop down list that appears, we select "Check
Condition", as follows:
Click "OK", and the Sequence 0 we are building now looks as follows:
Note again that the existing of a event without an action to complete the state is flagged
by the yellow bar along the top and the yellow dot to the left of the incomplete command.