Teledyne LeCroy SAS Suite User Manual - Manual (Page 268)

Version 6.25 SASSuite User Manual
258
LeCroy Corporation
Preparing to Track a Command Sequence
Before starting to track commands with the SASTracker Command Analyzer, you should
first set up the recording options by selecting Tracker Options under the Tracker menu
(or under the Setup Menu--but do not use "Recording Options", that selection applies to
SASTracer only).
Note: If you have more than one SASTracker System attached, you will
see a submenu allowing you to choose whether to set the Tracker
Options for all systems, or for a specific system only.
Note: In this and the following sections, the menu selections available in
the Tracker menu are also available as icons in the Tracker Toolbar,
as follows:
Tracker Buttons
Start Tracking
Tracker Options (if multiple
SASTracker systems are
connected, this button is used for
"All Devices" by default).
Stop Tracking