Health support equipment – Lincoln Electric 718115 Spirit II 275 User Manual
Page 10
Section 1: Safety
Spirit II User’s Manual
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
1-4
•
Compressed gas cylinders should be maintained properly. Never attempt to use a
cylinder that is leaking, cracked, or has other signs of physical damage.
•
All gas cylinders should be secured to a wall or rack to prevent accidental knock
over.
•
If a compressed gas cylinder is not being used, replace the protective valve cover.
•
Never attempt to repair compressed gas cylinders.
•
Keep compressed gas cylinders away from intense heat, sparks, or flames.
•
Clear the compressed gas cylinder connection point by opening the valve
momentarily prior to installing a regulator.
•
Never lubricate compressed gas cylinder valves or pressure regulators with any type
of oil or grease.
•
Never use a compressed gas cylinder or pressure regulator for any purpose other
than which it is intended.
•
Never use a pressure regulator for any gas other than which it is intended.
•
Never use a pressure regulator that is leaking or has other signs of physical
damage.
•
Never use oxygen hoses and pressure regulators for any gas other than oxygen.
•
Never use any gas hose that is leaking or has other signs of physical damage.
Health Support Equipment
The Spirit system creates electric and magnetic fields that may interfere with certain
types of health support equipment, such as pacemakers. Any person who uses a
pacemaker or similar item should consult a doctor before operating, observing,
maintaining, or servicing the system. Observe the following guidelines to minimize
exposure to these electric and magnetic fields:
•
Stay as far away from the power supply, torch, torch leads, and impulse start
console as possible.
•
Route the torch leads as close as possible to the work ground cable.
•
Never place your body between the torch leads and work ground cable. Keep the
work ground cable and the torch leads on the same side of your body.
•
Never stand in the center of a coiled up set of torch leads or work ground cable.