Lincoln Electric 718115 Spirit II 275 - Manual (Page 127)

Spirit II User’s Manual Section 6: Maintenance &Troubleshooting
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
6-7
Error Codes
The following is a comprehensive list of error codes for the Spirit system. When the system
uses a Manual Gas Console, only the numeric error code is displayed. When an Automatic
Gas Console is used, the text description is also displayed.
Power Supply
Code Short Description Long Description
10121 ISC Door ISC Door is open
10138 Stop Pressed (Off Button) OFF Button on Plasma Console or Manual Gas
Console is pressed.
10140 Phase R Transformer Secondary phase voltage is low
10150 Phase Y Transformer Secondary phase voltage is low
10160 Phase B Transformer Secondary phase voltage is low
10161 CON1 Main Contactor failed to open
10170 Coolant Level Coolant Level is low
10180 Coolant Flow Low Coolant flow is low
10190 Coolant Flow High Coolant flow is high
10220 Coolant Temperature High The coolant temperature is high
10290 GC Quiet Lost CAN communication with Gas Console
10300 PC Quiet Lost CAN communication with Plasma Console
10320 FCC Invalid Final Cut Current invalid
10330 PAC Invalid Pilot Arc Current invalid
10340 AH IHS Timeout Arc Hold for Initial Height Sense has timed out
10350 PAT Not Established Pilot Arc Current not established within 2 seconds
10360 TAC Not Established Transferred Arc Current not established within 2
seconds
10370 Current Unbalanced Current is not balanced between chopper
assemblies (275A and 400A systems)
10380 TAC Lost 1 Transferred Arc lost during TAC hold time
10390 TAC Lost 2 Transferred Arc lost during Upslope
10400 TAC Lost 3 Transferred Arc lost during Cutting
10410 TAC Lost 4 Transferred Arc lost during Downslope
10420 FCC Unreached Did not achieve final cut current
10430 Output Over Current Chopper has exceeded its maximum rated current
10432 Output Over Current TZ Instantaneous Over Current detected
10440 Output Over Voltage Maximum Cutting Voltage has been exceeded.
10450 Start Premature Removal Start Signal removed prior to completion of upslope
10461 Chopper1 Temp Chopper 1 maximum operating temperature
exceeded
10462 Chopper2 Temp Chopper 2 maximum operating temperature
exceeded
10463 Chopper3 Temp Chopper 3 maximum operating temperature
exceeded