Lincoln Electric 718115 Spirit II 275 - Manual (Page 59)

Spirit II User’s Manual Section 4: Operation with Automatic Gas Console
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
4-13
Configuration Tab
Press the Config navigation button followed by the Configuration tab to access the
screen described below.
RS422 Parameter Control
Controls how the Spirit communicates with the X/Y controller and height control system.
If an Inova arc voltage control system is not being used with the Spirit system, RS422
Parameter Control must be disabled. With the RS422 Parameter Control set to
automatic, the Inova is automatically updated with the correct arc voltage, pierce (initial)
height, and cutting (marking) height any time a new condition is loaded, the process
(cutting or marking) is changed, or when the arc voltage, pierce (initial) height, or cutting
(marking) height is changed on the Parameters Screen.
With the Inova Parameter Transmit feature set to manual, the voltage screen is being
displayed will automatically transmit the pierce (initial) height, cutting (marking) height,
and arc voltage set points to the Inova.
Cut/Mark Control
The Spirit system has the capability of plasma cutting and plasma marking with
the same set of consumables. The process (cutting or marking) can be set by
the RS-422 serial interface (COMM), by a hard signal (Hard Wire) on the CNC
interface plug, or locally (Local) through the plasma console.
Hydrogen Cutting (H17)
When hydrogen cutting is enabled, the H17 hydrogen mixture will automatically
be selected as the plasma gas for certain material types and thicknesses. To
prevent the use of H17, hydrogen cutting must be disabled.
Units of Measure
The Spirit system will display Imperial units or Metric units. Press to select.
Language
Press to select the desired language.