Lincoln Electric 718115 Spirit II 275 - Manual (Page 63)

Spirit II User’s Manual Section 4: Operation with Automatic Gas Console
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
4-17
Updating the Software
1. Copy the file Installer.exe onto a USB thumbdrive. This file will be emailed or an ftp
address will be provided for download.
2. Turn the Plasma Console off.
3. Insert the USB thumbdrive into either port on the back of the Plasma Console.
4. Turn the Plasma Console on.
5. Allow the system to boot to the normal main screen and select “Config” from the
Navigation Menu.
6. Select the “Software Updates” tab.
7. Using the arrows, navigate to the software package to be installed. Note that the
system will overwrite the file without warning if steps aren’t taken to rename the
default Installer.exe file. If you wish to maintain older software updates, you may
wish to rename the file to something like Installer mm/dd/yy_Installer.exe
8. Select the Install button.
9. At this point the Plasma Console will shut itself down and run the installer package.
10. To complete the install follow the onscreen instructions.
11. For the most basic installation, a new screen will be shown and simply clicking Install
will perform the update. In the event of a software upgrade to the Gas Console
and/or the Power Supply, further actions will be required. Again, follow the onscreen
instructions to complete the install.