Lincoln Electric 718115 Spirit II 275 - Manual (Page 42)

Section 3: Installation Spirit II User’s Manual
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
3-18
Plasma Console Connections
Perform the following steps to connect the plasma console to the Spirit system.
CAN Communications
• Insert the male end of the CAN communication cable. See "CAN Communication
Connections" for more details.
CAN Communications
• Insert the female end of the CAN communication cable or the CAN termination plug,
depending upon the connection scheme. See "CAN Communication Connections"
for more details.
RS-422 Communication
• Insert an RS-422 cable, if necessary, to connect to other devices.
RS-422 Communication
• Insert an RS-422 cable, if necessary, to connect to other devices.
USB
• Either USB port can be used to update the Spirit II software.
Ethernet
• No connection. For future development.
41
40
38 39 36 37
37
36
38
39
40
41