Yokogawa RAMC - Manual (Page 28)

<6. ELECTRONIC TRANSMITTER (-E)>
6-2
IM 01R01B02-00E-E 10th edition January 01, 2013 -00 All Rights Reserved. Copyright © 2003, Rota Yokogawa
The buttons access three functions:
- upper button ( ↑ ) : Exit setting mode
- lower button ( → ) : Scroll through menu/selection of parameters
- both buttons ( ↑ + → ) = Enter : Entering parameters/selecting setting mode
If no button is pressed for one minute while the operating menu is active, the indication reverts to the
measuring indication. This does not apply to subfunctions F32, F33, F52, F63.
For indication of volume or mass values at maximum 6 digits in front of the decimal point and 7 decimals are
used. This format allows an indication range for flow rates from 0.0000001 unit/time to 106000 unit/time. Flow
rate values exceeding 106000 are shown as ‘————’ on the display. In this case the next bigger flow rate unit
(next smaller time unit) has to be selected.
For the indication of totalizers values 8 digits are used at maximum of which 7 digits can be assigned for
decimal values. The decimal point setting is determined by selecting the unit. Therefore, possible totalizer
offsets are:
Unit *1
Unit *1/10
Unit *1/100
The totalizer counts up to 99999999 or 9999999.9 or 999999.99 and is reset to zero.
The next page shows the operating menu.
The following describes selection and execution of functions.
Menue :
Indication meas .val F1- : Indication F11 : Selection F11-1 : Flow rate
F11-2 : Totalizer
F11-3 : %
F11-4 : Temperature
Euro / US
F12 : Flow rate unit F12-1 : m³ / m³
F12-2 : l / acf
F12-3 : Nm³ / Nm³
F12-4 : NL / scf
F12-5 : t / ton
F12-6 : kg / kg
F12-7 : scf / lb
F12-8 : gal / usg
Euro / US
F13 : Time unit F13-1 : h / h
F13-2 : min / min
F13-3 : s / s
F13-4 : day / day
F14 : Reset Totalizer F14-1 : Execute
F15 : Temperature unit F15-1 : degC
F15-2 : DegF
F2- : Damping F21 : Selection F21 0 : 0 s
F21 1 : 1 s
F21 5 : 5 s
F21 10 : 10 s