Yokogawa Wireless Temperature Transmitter YTA510 - Manual (Page 38)

<7. Setting Parameters>
7-6
IM 01C50E01-01EN
• Block Info
• Block Mode
• Dynamic Variables
• Configuration
• Others
(AI1/AI2 Temp)
•Tag Description
(Block Info)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Process Value
• Simulation
• Reference Junction Temp
(Dynamic Variables)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Transducer Value.Status
• Transducer Value.Value
(Transducer Value)
• Simulate Value.Status
• Simulate Value.Value
(Simulate Value)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
• Lin Type*
• Sensor Connection *
• Bias *
• Selection of Reference Junction *
• External Reference Junction Value *
• Process Value Type *
• Burn Out Type *
(Configuration) (Block Mode)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Scale)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
• Sensor Serial Number
• Sensor Range *
• Cal Point Lo/Hi *
• Cal Point Clear *
• Reference Junction Unit *
(Others) (Sensor Range)
• Sensor Range.EU at 100%
• Sensor Range.EU at 0%
• Sensor Range.Units Index *
• Sensor Range.Decimal *
Online Menu (Continued)
F0702-4.ai
• Block Info
• Configuration
/Calibration
• Others
(TRANSDUCER)
• Tag Description
(Block Info)
• Model
• Serial Number
• Hardware Burn Out Switch
• Wireless Status
• Display Selection
• LCD Mode
• LCD Intermittent Time
• YTA Option
• Power Saving Mode
• Measurement Rate
(Configuration/Calibration)
• Special Cmd
(Other)
*: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).
**: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to Manual.