Yokogawa Wireless Temperature Transmitter YTA510 - Manual (Page 42)

<7. Setting Parameters>
7-10
IM 01C50E01-01EN
• UAPMO
(Diagnostic)
Online Menu (Continued)
F0703-4.ai
• AI1/AI2 Temp
(Process Variable)
• Device Diagnostics
(UAPMO)
• Process Variable
(AI1/AI2 Temp)
• Diagnostic Status
• Diagnostic Status Detail.1
• Diagnostic Status Detail.2
• Diagnostic Switch
• Diagnostic Configuration
(Diagnostics)
• Process Value
• Simulation
• Reference
Junction Temp
(Dynamic Variables)
• Energy Left
• Power Supply Status
• Power Supply Voltage
(Power Status)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
• Transducer Value.
Status
• Transducer Value.
Value
(Transducer Value)
• Simulate Value.
Status
• Simulate Value.
Value
(Simulate Value)
• Configure/Setup
(AI1/AI2 Temp)
• Tag Description
(Block Info)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
• Lin Type*
• Sensor Connection *
• Bias *
• Selection of Reference Junction *
• External Reference Junction Value *
• Process Value Type *
• Burn Out Type *
(Configuration)
• Sensor Serial Number
• Sensor Range *
• Cal Point Lo/Hi *
• Cal Point Clear *
• Reference Junction Unit *
(Others)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
(Scale)
• Sensor Range.EU at 100%
• Sensor Range.EU at 0%
• Sensor Range.Units Index *
• Sensor Range.Decimal *
(Sensor Range)
• Diagnostic.Other Faults
• Diagnostic.Faults Non-Compliance
• Diagnostic.Faults Process Influence
• Diagnostic.Simulation Active
• Diagnostic.Soft Update Incomplete
• Diagnostic.Power Low
• Diagnostic.Power Critical Low
• Diagnostic.Fault Prediction
• Diagnostic.Environmental Conditions
• Diagnostic.Outside Sensor Limits
• Diagnostic.Out of Service
• Diagnostic.Calibration Problem
• Diagnostic.Faults Sensor or Actuator
• Diagnostic.Faults Electronics
(Diagnostic Configuration)
*: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).
**: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to Manual.